DALL’FUG creates a strongly water-repellent, non film-forming impregnation on the surface, and retards the development of micro-organisms. It totally impregnates the support without modifying either the colour or the abrasive resistance of the concrete.For reinforced local or general protection against fat stains, it is essential to provide a DALL’TACH over-coat.


All smooth or structured concrete surfaces on which a film-forming product could become slippery in the presence of water : swimming-pool borders, terraces, public areas, etc… Concrete surfaces have to be two weeks old at least. Remove dust and efflorescence from the concrete suface.


On recent surfaces :
Ready to use Apply with a roller or spray on entirely dry surface. Do not apply in rainy weather.Upper and lower support and air.Temperature limits during application : +5°C to +35°C;Usual consumption : 5 to 8 sqm/l ; with very absorbent supports, apply a second coat once the first has dried.

On old surfaces :
Before applying DALL’FUG, decontaminate the surface applying DALL’MOUSS
(consult our technical data sheet) and rinse it out with water (with a low pressure).

Avoid putting this product in excess in the hollows, it can generate stains difficult to eliminate. The combustible character of the product has to be taken into account, the use of thermal engine to pulverize it is prohibited.


• Colourless solvated liquid.
• Density : 0.8 * 0.02
• Flash point : 62°C (Setaflash method)
• Viscosity : <7 cSt ,
• Iso cup 2431 N° 3 at 20°C;
• Drying time : 3-4 hours at 20°C and 50% RH intensive to rain once completely dry.
• Stable with U.V.
• Pipe of spray : X 5 or X 8 (recommended)


The treatment does not modify in a significant way the initial slipperiness of the tiles (dry or wet).

2 years in original packaging


5 liter metal jerry can.


Harmful: can damage lungs in case of ingestion. The repeated exposure can cause dryness or cracks of skin. For further information, consult our Safety data sheet.

Not regulated.